Kids' shirt: sewing steps in pictures

The sewing steps from “How to sew a kids' shirt”, one at a time, each with a diagram. Tap the round numbered buttons to move between steps.Red line = sew here. Blue dotted line = leave open or fold.

1. Sew the shoulders

  1. Both fronts (wrong side up) on the back (right side up) Front (wrong side) Front (wrong side) Sew both shoulders The front overlaps cross at the center
    Both fronts on the back, right sides together; sew the shoulders

    Place both fronts on the back and sew the shoulders

    Lay the back right side up and place the two fronts on it wrong side up, so the right sides face each other. Line up the shoulder ends and the neckline ends, pin, and sew along the stitching line 1 cm (3/8 in) from the edge.

  2. Back Front Zigzag the allowances (both layers together) Press to the back
    Finish both allowances together and press them toward the back

    Finish the allowances and press them to the back

    Serge or zigzag both allowances together. Open the body out flat and press the allowances toward the back.

2. Set the sleeves

  1. Back Front Sleeve Match the notches and sew the armhole
    Match the notches and sew along the armhole

    Match the notches and sew the armhole

    Lay the body flat and place a sleeve on it right sides together. Match the center notch to the shoulder seam and the ends of the sleeve to the underarm, pin, and sew the armhole from end to end. Finish both allowances together and press them toward the sleeve.

    The sleeve head is almost the same length as the armhole, so set it in without easing.

3. Sew the sides and underarms

  1. Front (wrong side) Sew cuff → underarm → hem in one seam
    Sew cuff → underarm → hem in one seam

    Sew from the cuff to the hem in one seam

    Fold right sides together at the shoulders and match the armhole seams exactly at the underarm. Sew from the cuff, through the underarm and down to the hem with a 1 cm (3/8 in) seam. Finish both allowances together and press them toward the back.

4. Attach the front facings

  1. Front (RS) Facing (WS) Facing right sides together; sew the front edge to the hem Turn it to the inside; baste the neckline inside the allowance Cross-section Body (RS) Facing Roll the facing slightly inside
    Facing right sides together; sew the front edge to the hem line

    Sew the facing to the front edge

    Place the interfaced facing on the right side of the front, right sides together. Line up the front edge, pin, and sew from the neckline down to the hem line.

  2. Front (RS) Facing (WS) Facing right sides together; sew the front edge to the hem Turn it to the inside; baste the neckline inside the allowance Cross-section Body (RS) Facing Roll the facing slightly inside
    Turn the facing, roll the edge slightly and press

    Turn the facing and press the edge

    Turn the facing to the inside, roll the edge about 1 mm toward the inside so the facing doesn't show, and press. Baste the facing and front together at the neckline, inside the allowance.

5. Attach the stand collar

  1. Outer and under collar right sides together; sew the top and ends Leave the neckline edge open Trim the corners and turn
    Outer and under collar right sides together; sew the top and ends, then turn

    Sew the outer and under collar and turn

    Place the interfaced outer collar and the under collar right sides together and sew the top edge and both ends, leaving the neckline edge open. Trim the corners and turn right side out, then press.

  2. Back Front Collar ends at the front edges; sew through the facings Collar end = front edge
    Collar ends at the front edges; sew the outer collar to the neckline

    Sew the outer collar to the neckline

    Pin the outer collar to the neckline right sides together, with its ends at the front edges and its notches at the shoulder seams and center back, and sew through the facings. Clip the curved neckline allowance.

    The collar is the same length as the neckline from front edge to front edge. If an end drifts off the front edge, re-pin from the notches.

  3. Back Front Fold the under collar over the seam and topstitch round the collar
    Fold the under collar over the seam and topstitch round the collar

    Fold the under collar over and topstitch

    Fold under the allowance of the under collar, lay it over the neckline seam to hide it, and pin. Topstitch all round the collar about 2 mm from the edge.

6. Finish the hem and cuffs

  1. Front (wrong side) Double-fold the hem and cuffs and stitch Cross-section Stitch by the fold Wrong side Fold twice (double fold)
    Double-fold the hem and cuffs and stitch

    Double-fold the hem and cuffs and stitch

    Turn up the hem and cuffs 1 cm and then 1 cm again (a double fold), press, and stitch close to the fold. Fold the bottom of the front facings into the hem and stitch them in with it.

7. Buttons

  1. Center front Vertical buttonholes on the center-front notches Buttons on the center front of the other side
    Vertical buttonholes and buttons at the center-front notches

    Make the buttonholes and sew on the buttons

    On the upper front, work vertical buttonholes at the center-front notches, and one horizontal buttonhole in the collar. Sew the buttons on the other front and the collar.

Make the pattern free with Katagami. Change the size and try it straight away.

Open the pattern tool →

‹ Back to how to sew a kids' shirt